On Screen Values, Metrics, Gauges, and Graphs

simulation training & tutorials

Rate this article:

5.0

Begin by adding a Start Process, Generic Process and an End Process.
Connect the flow.
Add a Results Process underneath Start.
- Click “Add Parameter” and fill out the table as shown.
- Change the Display Type to “Vertical Bar.”
- Select “Use One Maximum Value” and set it to 100.
- Set the “Update Interval” value to 10 seconds.
- Make sure your properties match those on the screen.
Use the Selection Tool to resize the Results Process..
Run the simulation.
Double-Click the Generic Process
- Open its Process Timing Properties.
Add another Results Process underneath End.
- Fill out the information as shown.
- Set the Display Type to “Line Graph.”
Place a third Results Process and put it under the Generic Process.
- Fill out the information as shown.
- Select the box labeled “Capture historical data for additional analysis.”
- Set the Display Type to “Text Values.”
Open the “Model Analysis” tab.
Scroll down to view the “Model Variables” table.
Stop the simulation.
Under the “Analysis” tab, you can view results graphs by clicking “Dynamic Data Graphs.”

Number of views (8327)/Comments (0)